Black cooktop set into a stone kitchen benchtop
Upgrades

Swapping a gas cooktop for induction: the wiring you need

Swapping a gas cooktop for induction in Victoria: the circuit it needs, who caps the gas, the $140 discount and what the gas rules do and do not require.

  • Licensed & insured
  • Local Frankston Team

Short answer

An induction cooktop is hard-wired by a licensed electrician, and most need a circuit of their own run back to the switchboard. A licensed gasfitter disconnects and caps the old gas line.

Victoria does not make you replace a working gas cooktop, and there is a discount of about $140 if you choose to.

On this page
  1. The key facts
  2. Do you have to replace a gas cooktop?
  3. What an induction cooktop needs electrically
  4. What we check before the old one comes out
  5. The gas side is a gasfitter’s job
  6. The Victorian discount for replacing gas with induction
  7. Pans, and one health note

The key facts

  • Most good-quality induction cooktops draw more than 15 amps, which is more than a standard household circuit supplies.
  • The cooktop is hard-wired by an electrician and will likely need a new dedicated circuit.
  • Three-phase power is unlikely to be needed. Single phase suits most homes.
  • A licensed gasfitter decommissions and caps the gas cooktop.
  • No Victorian rule requires an existing gas cooktop to be replaced.
  • The Victorian Energy Upgrades discount is about $140, claimed through an accredited provider.

Do you have to replace a gas cooktop?

No. The Victorian Government’s page for existing homes says there is no requirement to replace existing gas cooktops or gas heating. A home already on gas can stay connected, and its gas appliances can still be used, maintained and repaired.

Two dates are coming, and neither is about cooktops in existing homes:

  • 1 January 2027. New homes and most new commercial buildings must be built all-electric. It applies to building permits issued from that date.
  • 1 March 2027. A gas hot water system in an existing home that breaks and cannot be repaired must be replaced with an electric one.

For rentals, the energy efficiency standards that start on 1 March 2027 cover ceiling insulation, shower heads, hot water, heating, cooling and draughtproofing. Cooking appliances are not on the list.

What an induction cooktop needs electrically

The Victorian Government’s induction buyer’s guide puts it plainly. Most good-quality induction cooktops need more than 15 amps, which is above what standard household circuits commonly supply. The cooktop needs to be hard-wired by an electrician, and it will likely need a new dedicated circuit back to the switchboard when the existing circuits cannot supply it.

Each cooking zone typically reaches 1,600 to 3,000 watts, and boost mode can go past 4,000 watts on a zone. That is why the circuit that ran an old electric cooktop, or the power point behind a gas one, is often not enough.

  • Switchboard. If no new circuit can be added to the board, it may need an upgrade first. Our guide to whether you need a switchboard upgrade covers the signs.
  • Three-phase. Unlikely to be needed. Older houses may need the connection and wiring upgraded.
  • Isolating switch. Energy Safe Victoria requires one that is visible and easy to reach, within 2 metres of the cooktop and not on the appliance itself.
  • Clearances. No switch or power point within 150 mm of the edge of the cooking surface.
  • Plug-in models. Some cooktops plug into a standard socket. An electrician should still check what else is on that circuit.

Have the circuit checked before you buy the cooktop. The rating plate of the model you want decides the circuit, not the other way round.

What we check before the old one comes out

We check the cooktop’s rating plate against your existing circuit before anything is disconnected. If it needs a dedicated circuit, we run one from the board, sized for the appliance and protected by its own safety switch and circuit breaker. The cooktop is hard-wired with the isolator somewhere you can reach it, then the circuit is tested.

You get a fixed price before we start and a Certificate of Electrical Safety when the work is done. The scope is on our oven and cooktop installation page.

The gas side is a gasfitter’s job

Decommissioning and capping an existing gas cooktop requires a licensed gasfitter. Energy Safe Victoria says to use one for any gas work, including renovations where a gas appliance is disconnected. Removing an appliance changes the gas installation, and the Building and Plumbing Commission requires a compliance certificate for work on consumer gas piping.

We do the electrical work. You book the gasfitter, and the two visits are usually arranged around the day the benchtop is cut or the new cooktop arrives.

The Victorian discount for replacing gas with induction

Victorian Energy Upgrades offers a discount for replacing a gas cooktop with induction. The government’s page gives an indicative figure of $140 per cooktop. It moves with the price of the certificates behind the program, so treat it as about $140, not a fixed amount.

Who can get it:

  • A Victorian household with a gas cooktop to replace, in a home built at least two years ago. Private rentals are eligible.
  • No induction discount claimed at the property before.
  • A built-in induction cooktop, or a freestanding stove with an induction top. Portable and plug-in benchtop units are excluded.
  • At least 550 mm wide and 380 mm deep, with three or more zones and a warranty of two years or more.

It is not taken off the price at the shop. You buy from any retailer and keep the invoice, then an accredited provider processes the claim. They need the invoice and a recent gas bill. Installation can be arranged separately with your own licensed tradespeople.

Talk to an accredited provider before you buy. Claims made after the fact are not guaranteed.

Pans, and one health note

Induction needs pans with a magnetic base. If a fridge magnet does not stick to the bottom of the pan, it may not work. Round-bottomed woks may not work well.

The government guide advises anyone with a pacemaker or other implant to talk to their doctor first.

Sources

Read on 21 November 2026. Rules change. Check the linked page for the current wording.

Common questions

What does it cost to switch from gas to induction?
It depends on the cooktop, how far the new circuit has to run and whether the switchboard has room. The Victorian Government’s buyer’s guide, listed under Sources, gives typical ranges for the cooktop, the wiring and capping the gas. We give you a fixed price for the electrical work before we start.
Will I need a new switchboard?
Only if the board cannot take another circuit. Many can. If the main switchboard is replaced, the power stays off until a licensed electrical inspector has inspected the work.
Can a renter get the discount?
Private rentals are eligible under the program’s rules. The cooktop is fixed to the property, so the rental provider has to agree to the change.
Can the same electrician cap the gas?
Not unless they also hold a gasfitting licence. Gas work is licensed separately from electrical work. We are electricians, so the gas is capped by a gasfitter you book.

What we can do

  • Oven and cooktop installation

    Hard-wired ovens and induction cooktops, with the dedicated circuit when one is needed.

    Oven and cooktop installation
  • Switchboard upgrades

    A board with room for the new circuit, with safety switch protection on every circuit.

    Switchboard upgrades

More articles from the blog

Get the circuit checked before you buy

Pick any
Your details

Talk to a licensed electrician

Based in Frankston North. Fixed price before we start. After-hours call-outs for urgent faults.