The rule
Section 38 of the Electricity Safety Act makes it an offence to carry out electrical installation work without a licence. “Electrical installation” means the fixed electrical equipment in a building: the switchboard, the cables, the power points, the switches, the light fittings and anything wired in. “Work” means installing, altering, repairing or maintaining it.
There is no exemption for a homeowner. Victoria once had an occupier’s licence. It was abolished in 2010.
Energy Safe Victoria, the regulator, puts it this way: “There’s no grey area. Always hire a licensed electrician.”
Advice from overseas websites and videos does not apply here.
Jobs that need a licensed electrician
| Job | Can you do it yourself? |
|---|---|
| Replace a power point, or add one | No. Energy Safe Victoria names power points specifically |
| Replace a light switch or a dimmer | No. Named specifically as well |
| Replace a light fitting, or add downlights | No. The fitting is wired into the house |
| Install a ceiling fan or a wired-in exhaust fan | No |
| Connect an oven or cooktop that is wired in | No |
| Install or replace a hard-wired smoke alarm | No. It must be done by an electrician |
| Install a split system air conditioner | No |
| Install a wall-mounted EV charger | No. United Energy requires a Registered Electrical Contractor |
| Install solar or a home battery | No. The work is also inspected by a licensed electrical inspector |
| Repair a cracked or loose power point | No. Cover it and have it replaced |
| Repair a faulty appliance or a damaged cord | No. Energy Safe Victoria says a qualified repairer or a licensed electrician |
What you can do yourself
- Test and reset a safety switch. Energy Safe Victoria publishes the steps and says to do it every three months.
- Change a smoke alarm battery. Consumer Affairs Victoria’s wording is that anyone can.
- Plug in and unplug appliances. Anything that is easily moved and connects by a plug to a power point is not part of the fixed installation.
- Plug in an oven or cooktop that comes with a plug, where a suitable power point is already there. The Victorian Government’s buyers guide says to have an electrician check the circuit first.
- Use a portable safety switch on a lead or a power tool.
- Put up solar or plug-in extra-low-voltage lights outside. These run at 5, 12 or 24 volts. Energy Safe Victoria recommends them as the safest option for outdoor and Christmas lighting.
- Plug ready-made leads into your modem, router, television and computer.
Energy Safe Victoria does not publish a full list of what a householder may do. The Act covers work on the fixed installation. A light globe, like anything with a plug, is not part of the fixed wiring. Switch the light off before you change one.
Fuses
If a ceramic fuse keeps blowing, something is wrong on that circuit. Never fit heavier fuse wire to make it hold. The wire is sized to protect the cable in the wall.
A fuse gives no protection against electric shock. Our guide to whether you need a switchboard upgrade covers what replaces it.
Data and ethernet cable
This one is a federal rule, enforced by the Australian Communications and Media Authority.
You can connect equipment with ready-made leads. Cable that is concealed in a wall, floor or ceiling cavity and connects to the telecommunications network must be installed by a registered cabler, or under one’s supervision. The cabler gives you a signed statement that the work complies with the wiring rules.
Our data point installation page covers how we run cable to another room.
The fines
Penalties are set in penalty units. One unit is $209.10 in 2026-27.
| Offence | Maximum for an individual |
|---|---|
| Carrying out electrical installation work without a licence | 50 penalty units, $10,455 |
| Knowingly installing electrical equipment that is unsafe | 240 penalty units, $50,184 |
| An owner who is told an installation is unsafe and does not make it safe | 240 penalty units, $50,184 |
The penalty for knowingly unsafe work rose from 40 to 240 penalty units in May 2025. The penalty for unlicensed work did not change.
Energy Safe Victoria publishes its prosecutions. In May 2023 a court fined a man $10,000, with a conviction, for unlicensed electrical and plumbing work that included fitting split systems and light fittings at five properties.
What a licensed electrician must give you
A Certificate of Electrical Safety. Electricians must issue one for all electrical installation work in Victoria, however small. For most household jobs you should have it within about a month. An electrician cannot refuse to issue one over a payment dispute.
Two checks before anyone starts:
- Ask to see the licence. Energy Safe Victoria tells customers to do this.
- Search the name or licence number on Energy Safe Victoria’s public register.
If a tradesperson will not show a licence or does not give you a certificate, Energy Safe Victoria asks you to contact them.
If a previous owner did their own wiring
It turns up in older houses: a power point added off a light circuit, joins wrapped in tape in the roof, a shed fed by an extension lead buried in the garden.
Have a licensed electrician check and test it. An electrical safety check covers the whole house and gives you a written report. What we find is listed with a price to fix each item.
The small jobs
Most of what people want to do themselves is a small job for an electrician: a cracked power point, a new light fitting, a fan where there is a light. Send us the list and we will give you a fixed price for the lot before we start.